EPC Space EPCS4001 Radiation-Hardened DC-DC Controller
EPC Space EPCS4001 Radiation-Hardened DC-DC Controller is a CERN-designed (the European Organization for Nuclear Research), PWM buck controller optimized for gallium nitride (GaN)-based power stages in space and high-energy physics applications. The controller supports a 17V to 50V input range, integrates 5V and 12V bias regulators, and operates at adjustable switching frequencies from 0.5MHz to 3MHz. Designed for harsh radiation and magnetic-field environments, the EPC Space EPCS4001 offers high-bandwidth transient response, power-good monitoring, undervoltage lockout, and overtemperature protection. The radiation-hard-by-design architecture supports reliable DC-DC power conversion and distribution in satellite power systems and other mission-critical applications.
Features
- Optimized for GaN-based power stage EPC7011
- CERN-designed, rad-hard, voltage-mode controller ASIC
- 17V to 50V input voltage range
- Integrated 5V and 12V regulators for bias supply of the power stage
- 0.5MHz to 3MHz adjustable switching frequency range
- High-bandwidth feedback loop (100KHz) for fast transient performance
- Under-voltage lockout
- Over-temperature protection
- Power good output
- Enable inputs, low quiescent current
Applications
- Satellite power distribution and regulation systems
- Isolated and non-isolated DC-DC converters for spacecraft power architectures
- Point-of-load (POL) converters for spaceborne electronics
- Avionics and aerospace power management systems
- Payload power supplies for communications, imaging, and sensing equipment
- Launch vehicle power conversion systems
- High-reliability military and defense electronic power supplies
- Radiation-tolerant distributed power systems
- Battery-powered spacecraft subsystems
- Auxiliary power converters requiring high efficiency and fast transient response
Specifications
- 13V to 50V operating input voltage range
- 0.6V to 24V operating input voltage range
- 0.5MHz to 3MHz operating switching frequency range
- 3.3V maximum enable/power good voltage
- PWM
- 0% to 97% duty cycle range
- 40ns typical minimum on-pulse width
- Error amplifier
- 90dB typical DC gain
- 20MHz typical unity-gain bandwidth
- 10V/μs typical slew rate
- Enable
- 800mV typical start threshold
- 720mV typical stop threshold
- 10kΩ typical enable pin series resistance
- 500kΩ typical embedded enable resistor-to-GND
- Over-temperature protection
- 120°C typical start threshold
- 80°C typical stop threshold
Simplified Application Block Diagram
Control System Block Diagram
