MAX20446EVKIT#

影像僅供參考
請參閱產品規格

Mouser 編號：

700-MAX20446EVKIT#

製造商編號：

MAX20446EVKIT#

製造商：

Analog Devices / Maxim Integrated

說明：

LED 照明開發工具 Evaluation Kit for Automotive 6x120mA Hi

規格書:

MAX20446EVKIT# 規格書 (PDF)

航運提示：

Mouser目前不在您的地區出售本產品。

供貨情況

庫存：: 發生意外錯誤了。請稍後再試。

.hidden-for-nojs { display: none; } .pull-right-nojs { justify-content: flex-end; }

商品屬性	屬性值	選擇屬性
製造商:	Analog Devices Inc.
產品類型:	LED 照明開發工具
付運限制：	Mouser目前不在您的地區出售本產品。
RoHS:
產品:	Evaluation Kits
用於:	MAX20446
工作電源電壓:	4.5 V to 36 V
系列:	MAX2046
封裝:	Bulk
品牌:	Analog Devices / Maxim Integrated
產品類型:	LED Lighting Development Tools
原廠包裝數量:	1
子類別:	Development Tools
每件重量:	220.298 g

找到產品:

若要顯示類似商品，請選取至少一個核選方塊

至少選中以上一個核取方塊以顯示在此類別中類似的產品。

所選屬性: 0

篩選文檔:

規格書

MAX20446EVKIT# 規格書 (PDF)

RoHS Certificate (PDF)

CAHTS:: 8473302000
USHTS:: 8473301180
MXHTS:: 8473300401
ECCN:: EAR99

31FL323x LED Lighting Development Boards

ISSI 31FL323x LED Lighting Development Boards are development tools that evaluate ISSI multi-channel LED drivers. LED drivers are electrical circuits used to power light-emitting diodes. The fully assembled and tested board is powered by the Arm® Cortex®-M3 or 80C51 (IS31FL3235A-QFLS2-EB) with a 5V operating supply voltage. The evaluation boards have multiple display modes.

IS31LT3360 Demonstration Board

ISSI IS31LT3360 Demonstration Board is a fully assembled and tested PCB that uses the IS31LT3360 continuous mode inductive step-down converter. This ISSI board is designed to drive single or multiple series connected LEDs. This performance is achieved efficiently from a voltage source higher than the LED voltage.

MAX20446EVKIT Evaluation Kit

Analog Devices Inc. MAX20446EVKIT Evaluation Kit demonstrates the MAX20446, an integrated 6-channel high-brightness (HB) LED backlight driver with boost/SEPIC controller and I²C interface for automotive displays. The evaluation kit operates from a DC supply voltage between 4.5V and 36V, and the switching frequency can be set either at 2.2MHz or at 400kHz. The evaluation kit operates in I²C mode only. Spread-spectrum mode (SSM) is enabled by default for EMI improvement but can be disabled by acting on a register bit. The evaluation kit demonstrates phase-shifted pulse-width modulation (PWM) dimming. Dimming can be performed externally using a PWM signal applied to the DIM PCB pad or internally by programming the desired dimming frequency and individual duty cycle through I²C. The hybrid dimming feature can be enabled through a register bit to reduce EMI. The evaluation kit also demonstrates short-LED, open-LED, boost output under-voltage, over-voltage, and over-temperature-fault protection.