TPS2359RHHT

Texas Instruments
595-TPS2359RHHT
TPS2359RHHT

製造商:

說明:
熱插拔電壓控制器 Full Featured Dual S lot Adv Controller A 595-TPS2359RHHR

ECAD模型:
下載免費的庫載入器,為ECAD工具轉換此文件。瞭解更多關於 ECAD 型號的資訊。

庫存量: 201

庫存:
201 可立即送貨
工廠前置作業時間:
6 週 工廠預計生產時間數量大於所顯示的數量。
數量超過201會受到最小訂單要求的限制。
最少: 1   多個: 1
單價:
HK$-.--
總價:
HK$-.--
估計關稅:
包裝:
完整捲(訂購多個250)

Pricing (HKD)

數量 單價
總價
零卷 / MouseReel™
HK$124.86 HK$124.86
HK$98.72 HK$987.20
HK$92.23 HK$2,305.75
HK$84.99 HK$8,499.00
完整捲(訂購多個250)
HK$81.54 HK$20,385.00
HK$78.50 HK$39,250.00
HK$78.09 HK$78,090.00
5,000 報價
† HK$55.00 MouseReel™費用將加入您的購物車內並自動計算。所有MouseReel™訂單均不能取消和不能退換。

商品屬性 屬性值 選擇屬性
Texas Instruments
產品類型: 熱插拔電壓控制器
RoHS:  
Controllers & Switches
Programmable
15 V
8.5 V
4 Channel
3.1 mA
- 40 C
+ 85 C
SMD/SMT
VQFN-36
Reel
Cut Tape
MouseReel
No
品牌: Texas Instruments
開發套件: TPS2359EVM
濕度敏感: Yes
產品類型: Hot Swap Voltage Controllers
系列: TPS2359
原廠包裝數量: 250
子類別: PMIC - Power Management ICs
每件重量: 105.700 mg
找到產品:
若要顯示類似商品,請選取至少一個核選方塊
至少選中以上一個核取方塊以顯示在此類別中類似的產品。
所選屬性: 0

此功能需要啟用JavaScript。

CNHTS:
8542319090
CAHTS:
8542390000
USHTS:
8542390090
JPHTS:
8542390990
TARIC:
8542399000
MXHTS:
85423999
ECCN:
EAR99

Dual-Slot Controller: TPS2358/59

Texas Instruments´ TPS2358/9 dual-slot controllers manage two 12V rails and two 3.3V rails for Advanced Mezzanine Cards in ATCA™, µTCA™ or custom systems. These TI devices include hot swap, ORing, and status indicators for all four paths. An optional I2C interface provides programmability and monitoring with the highest integration, flexibility, and performance in one small package.

LM5060 High-Side Protection Controllers

Texas Instruments LM5060 High-Side Protection Controllers with Low Quiescent Current offers intelligent control of a high-side N-channel MOSFET during normal on/off transitions and fault conditions. The constant rise time of the output voltage results from the inrush current control. Both an Input UVLO (with hysteresis) and a programmable input OVP are provided, with an enable input offering a remote on or off control. The initial start-up VGS fault detection delay time, the transition VDS fault detection delay time, and the continuous over-current VDS fault detection delay time is programmed from a single capacitor. The MOSFET is latched off until either the enable input, or the UVLO input is toggled low and then high when a detected fault condition persists longer than the allowed fault delay time.